After adding a system, a telescope and a laser to the database, you need to add a new channel. To do this, click on the HOI channels in the System settings panel. This will take you to a page with a list of all availabe channels that are connected with your lidar systems. This list should be empty if this is the first time you add a system.
To add a new channel to the database click on Add HOI channel at the top right of the screen. This will take you to a new page were you can fill in the needed information. As before, the fields in bold are mandatory and you will need to fill them before you can save you new system.
The fileds you have to fill here are more, as many of these are used during the processing of measurements.
Warning
There is a last step, different from the previous cases, when saving a new channel. You need to connect your channel with a lidar system before you save, or else all your entry will be lost. Read carefully through this document (or directly the last section) to avoid any problems.
To start using the single calculus chain you will need to fill the following fields:
Before you finish, you need to attach your channel to one of your systems. To do this, go at the bottom of the page and select your system from the drop-down list in the System channels area.
When you are done, press the save button at the bottom right of the page. This will take you back to the list of your channels. If everything went OK your new channel you just added should appear in the list.